Review on 🖨️ OVERTURE Dimensionally Accurate Filament Consumables: Leading 3D Printing Supplies for Additive Manufacturing by Payton Luna

I started closing my Ender 3 but after getting three sides I was impatient and tried this ABS out without ending it. Impatience was the working word, which I typed even faster than PLA and with a thicker stroke than usual. I was looking for functional, high strength parts that would withstand dirty water and outdoor conditions (birdbath or pond) and I wasn't disappointed. Pros: Fast printing. High quality, strong and durable prints. than any PETG I've tried. Inexpensive. Very little tension. Doesn't clog nozzles. when I'm indoors while printing. A little warping on the elongated parts, although much better than I expected (with a windscreen). If a pad is used, it is very difficult to remove. Edge works fine. Thin (two or three line widths) vertical parts are not very strong. Requires an all-metal hot end (On the Ender-3, I just replaced the thermal isolator with an all-metal thermal isolator for $2 for $15. https://www.amazon.com/gp/product/B08TCD4M1SNote: My Ender- 3 features a 50W heater, glass platform and all-metal thermal break Number of Wall Lines: 3 Print Temperature: 240°C Build Plate Temperature: 105°C Print Speed: 80°C Retract Activated: ON Retract at Shift Change: ON Retract Distance: 3.0mm Z-Hop On Distance: ONZ Hop Height: 0.4mmBuildplate Adhesion Type: BrimBrim Width: 8mm (ensure edges reach the windshield) Enable Windshield: One Windshield X/Y -Distance: 8mm