Review on 🔧 Aiskaer 20pcs 3mm Shank Tungsten Steel Solid Carbide Rotary Files Diamond Burrs Set for Woodworking Drilling Carving Engraving with Dremel Tool by Dave White

I bought this bit set to match my Dremel 8220 for carving decorative wood shapes and also for edging the dog house we are building. I am very satisfied with this set. I looked around and this was definitely the best deal for the quality and materials used to make these bits. They come in a case with a separate slot for each bit, which feels sturdy and helps keep them organized and sharp. To be honest, I had no problems with these beats. In doing so, I took the typical precautions of not driving the fine-tipped bits too deep into the board, which might break if pushed too far and moved to either side, but that's just the nature of bits in general (at least in my experience!) I'm not even sure this will be the case with carbide, but since some of these tips are so thin on the ends it would be wise to keep the tip. Tungsten carbide bits last much longer than what they sell at Harbor Freight or the typical steel bits you find at similar stores, so be aware that the additional cost you may pay for them is more than will pay off. . turns off after a while. Overall I highly recommend these beats and will definitely buy this brand if I need other styles in the future. PROS: Strong, durable materials, durable storage box, good range of shapes and cuts, good value for money. cost more than traditional steel bits. Precautions should be taken to prevent breakage/wearing of fine point bits*** Did you find this review helpful? Hopefully! Let me know if you have any questions using the comments section below ***