Review on 🔧 Creality Ultra Flexible Removable 3D Printing Plate - 310X310MM: Enhance your 3D printing experience! by Adam Tidd

Works great. I use it continuously, no heating on my 310x310 bed. No glue, hairspray or tape required. If you don't know how to level your bed and fix all the common imperfections like bed bolt nuts that weren't properly tightened under the bed before the bed spring and travel were smooth, then yes, you've come to the right problem with even the best of things . Learn how to fix your bed the right way before you blame a bad product. I'm totally blind and installed this with no help, everything went smooth and straight, just put on one cone while holding it straight on the bed, then roll up the other cone, then slowly pull back and flatten the mat. Mine just kept going. Also, make sure to clean the surface beforehand. You can print PLA without platform heat, I found this on a cheap $70 3D printer that didn't have a heated bed, and if you get it right you should be able to. even on a big bed. I just print, then I lift the mat up a bit and the model comes off without leaving a mess and I just use a paper towel with some detergent, let it dry and then start the next print. I sometimes use margins and sometimes no margins. I've printed 390mm height models and had no problems. PLA PLA Plus Note that this only applies to PLA and PLA+ printing, no problem for PPU either. However, don't expect to be able to print things hotter than 70°C. Haven't tried ABC as it's shrinking so won't try. Tip, if you don't want to stick this on your bed yourself, order an extra artwork and place a sticker mat with the smooth side on top. and then you can always replace your printing plate with these high temperature materials and don't worry about ruining the magnetic material. Also remember to account for Z height enter code ag 211 s0206 z-10.0 if using glass and this product above change code 206 to whatever you need to get the perfect bed height receive. The first code is to disable the z switch.