Review on 🔒 Ultimate Rim Protection: Stan's NoTubes Rim Tape for Rim Interior - 10 Yards by Tropingzz Cece

After 2 years of hoses the green slime hoses I was using finally ran out of gunk to stop another leak (snake bite from a new curb concrete pavement) in a to seal tires, so I went tubeless. I chose this material because it was relatively cheap and it was delivered within 3 days. It took me a while to figure out how to install this tape. The best way I've found is to lay it down and keep the roll 2-3 inches apart when pressed. press down firmly with thumb and slide along the inside of the rim 1/4 inch (0.5cm) at a time, this allows left to right control and also gives a decent seal around the rim, took about 20 minutes. I then went around and pressed the tape very firmly with my fingers over a piece of paper towel to reduce friction, looking for air bubbles or fewer areas of contact. Overall I'm very happy with the result and can't wait for the slime and tubeless valve to arrive.