Review on DPTOOL Steering Pulley Install Compatible by Mark Fleming
Husk too loose, nut too soft.
The bushing is so loose that it comes out crooked and will damage the pulley. I had to add six layers of aluminum tape to the assembly to get a good fit. Then it went smoothly. The nut on the bearing pusher is half sunk in it, also very soft. I couldn't pull the pulley all the way. I had to tap the nut and then use a large M8 nut to push the whole thing down. I would look elsewhere.
- Motor Tools
- Not sure
New products
Comments (0)
Top products in ๐ ๏ธ Engine Tools
๐ช Efficiently Cut Exhaust and Tailpipes with GEARWRENCH 2031DD Cutter
9 Review
๐ช Lisle 39000 Pulley Puller: The Ultimate Tool for Convenient Pulley Removal
9 Review
๐ง DPTOOL Engine Timing Tool Kit for Audi VW 1.8 2.0 TSI/TFSI EA888 - T10352 T40196 T40271 T10368 T10354 T10355
9 Review
Complete Ford 4.6L/5.4L/6.8L 3V Engines Repair Tools Set - Valve Spring Compressor, Crankshaft Positioning Tool, Cam Phaser Holding Tool, Timing Chain Locking Wedge with Crankshaft Pulley Bolt
10 Review
