Review on 🖥️ VIVO Black Adjustable Wall/Ceiling Projector Mount Bracket, Extendable Length Projection | MOUNT-VP06B by Eugene Cox

Very strong powder coated steel. Easy setup with a little creativity e.g. B. by sliding the adjustable feet back into the brackets so that the mounting hole faces inwards and not outwards. Depends on the projector. If there are 3 mounting points, simply remove one of the four levers by removing the screw. If you are wall-mounting and need the back of the projector close to the wall, place the mounting brackets on the projector so that the pipe attachment point is closer to the front of the projector. When used as a wall mount, the tube is attached to the bracket and the bracket is screwed to the wall instead of the ceiling. This will position the lever parallel to the ground, but don't try to tighten the bolts from the tube to the bracket expecting them to be tight enough to keep them parallel. You'll snap threads trying (don't ask me how I know that). So after cleaning a thread, I came to the realization that the hand will tip the nose down a few degrees until the pipe bottoms against the wall mount. Just let it hang and carefully tighten the screws. The steel of the mount is ridiculously strong and won't bend. Then simply lift the adjustable part of the assembly attached to the projector at a slight upward angle while attaching it to the end of the tube. Very, very adjustable projector.