Review on 🖨️ Eryone 3D Printer Filament: Enhancing Dimensional Accuracy of Additive Manufacturing Products by Christopher Millet

Loved the filament but took a hell of a time getting the material to stick. After many failed attempts, I was able to complete the 13-hour print with no problems. This material prints just like PETG, not PLA. Temperatures shown may work when printing at 10mm/s. My first layer I used 15mm/s, the other layers 110mm/s wall and 120mm/s infill. I had to heat the bed to 85 degrees and then lower it to 80 degrees and 235mm/s for the first layer and 240mm/s for the remaining layers for the rest of the print or it wouldn't stick to the textured base. Once I was able to get those temperaments right, the print quality was fine. No issues with getting stuck in the Bowden tube but after 3 hours of printing the filament twisted causing me to waste 3 hours of filament. So it was a bummer :( Otherwise I'm happy. Hopefully they can update the recommended print temperatures so people don't waste filament.