Review on 🔧 Atwood Motor Kit 37357 - Model 8531-35-III & DC89-III by Jeremy Sabey

The engine runs fine but it wasn't the same configuration as my old one or the picture they show here on Revain. This device they ship has two 12 inch crimp wires. . In this picture of the Revain and my old motor, the clamps are built into the motor. The extra wire doesn't fit well in the cover, and I had to make an adapter for the ground wire. Everything worked fine but I paid more for this unit because it looked the same as my other one...Only to find out it's the same model as a cheap one I could have bought instead. Plus, you don't need the rest of the included hardware. You can reuse everything that was in your old unit. Here's a great video showing the removal and installation of the engine. Use a 1/8" hex wrench with no ball on the end. You will most likely need a small flashlight to get the metal cage fan off the shaft. If all goes well, the engine swap takes less than two hours.