Right out of the box, this resin tank looked better than the plastic tank that came with my Anycubic Photon Mono. The FEP film turned out to be dense, although there were scratches and dents, as well as a cloudy substance that I tried to clean with isopropyl alcohol. It remained a little cloudy and appeared a bit greasy from the bottom out, but I went ahead and did a few test prints. The first complete failure, fully adhered to the FEP sheet. When I tried to take the bath out of the printer it stuck to the glass of the digitizer screen and wouldn't come off - on the next try it happened again so I think there's a tiny leak somewhere and the resin is kicking out on one side something out of. If the best FEP film was correctly installed on it, that could be great, but since it only came preinstalled, it's impossible to tell if it's a design issue or just a badly installed FEP film. I noticed that the FEP is held on with far fewer screws than my original barrel, which I found odd. It was recommended as an 'must buy' as an upgrade from the plastic maker case so I wasn't thrilled due to the high expectations.
BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)
7 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
🖨️ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review
🖨️ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
High-Precision And Stable Creality Ender 3 V2 3D Printer With New UI, Silent Mainboard, Effortless Filament Feed-In, XY-Axis Tensioner, Resume Printing, And Large Build Volume Of 220×220×250Mm
11 Review