🔧 Strong and Versatile Aluminum Tube Clamps for LED Light Bar and More: Roll Bar Clamps in 0.75 inch (3/4"), 0.875 inch (7/8"), and 1 inch Sizes Review

Excellent product! Installed on my 2018 Jeep JKU secondary bumper post. Well-made clips hold tight and look great. Take a little trial and error to figure out which parts of the pads to use (all included) but easy install and I'm very happy.

This thing is very easy to install. I installed it on the roll bar of my 2020 CSC RX4 along with Nilight LED headlights. the landing was ok, after the first ride i had to keep driving and tighten the screws again. I decided to loosen the screws and use thread lock just in case. Overall I will definitely buy again.

Works Great! I've used them on some of the LED lights on my bike and they snap firmly in place without moving. I changed the headlights after about 3 weeks and installed them somewhere else. By using the thinnest rubber inserts that came with the kit there were NO streaks on the powder coating when the old lights were removed. You were perfect.

I ordered two types of mounts and they won the dispute. I installed them on my boat's .875 rails. The other set came with foam tape to tighten the clamps and rubber inserts. They clung to the rail and didn't move! Another set could slide and roll and just couldn't handle a tough day on the water. Very happy with it! Glad I ordered them!

I was so excited when I found these jewels. I've seen similar products that fit much larger tubes, but none were that small. I use them to attach a set of cross braces to the basket on the roof of my Jeep that I have attached the solar panel to. If you have a pipe and want to attach something to it without drilling or welding then this is the ticket and the price is better than any I've found.