Worked perfectly for the Hustler Zero Turn we have. Hubby said it installed perfect & drainage completed in just a few mins.

Connected to Little Wonder blower for easier oil changes but takes forever to drain. Hose diameter is too narrow. That's my review.

I have a Toro zero-turn with a Kawasaki engine, FH series, but this drain hose does not work. This hose’s thread pattern does not match my engine. I am at a loss!

This hose fits Kohler CH440 engine. Worked well for the Power King wood chipper plenty of room to access exit chute. That's my review!

I installed three of these on various devices: leaf blower, chipper/shredder, and power generator. All have poorly placed plugs that would ordinarily create a mess. With the Drainzit device, oil changes are much simpler and vastly less messy. I've had no leaking issues, either. The only potential issue is securing the end so it does not interfere with normal operations. Fortunately, that has not been an issue in my case, but keep it mind, regardless.

I used this item to drain the oil from my Ariens Platinum 24 snow blower. The drain plug is on the side just above the left rear wheel. Unless you remove the wheel it is very hard to drain the oil without creating a mess. I tipped the blower on its opposite side, while I opened the drain plug, so it would not spill out. Then I attached this hose. Put the blower down and the oil drained out into a container thru the hose. It worked great and no mess. The problem is the hose is relatively stiff…

Works great on the predator engines. No problems at all I have a 301cc and it worked just fine. Makes it a lot easier to drain out the oil on my pulling tractor without making a mess on my nice paint.

Handy item and willing to give a try. Parts look to be of good quality but when installing into the Kawasaki FH680V it felt like the threaded fitting should have been as long as the original oil drain plug. It gives me a little uneasy feeling that it is only caught by a couple threads. What I am trying to explain is by the time you rotate to screw in and the first coarse thread catches the o-ring seats fairly fast.

Great product!I used this on my generator for easy maintenance because it is installed in an enclosure where the only door is for accessing the electric start. There would be no way to change the oil without a huge mess.I was going to make my own with various AN fittings and hose but the cost would have cost approximately the same.I simply had to unscrew the drain plug, and screw this one in place. This makes oil changes not only convenient but my intended enclosure design possible.

Installed this on my wood chipper, where the oil drain plug is there is no way to let the oil drain out without allot of it going under the engine mount then leaking out on the concrete shop floor for the next month. This quick drain hose went on without any trouble, should make it less of a hassle to change the oil.

I took a chance on this because it didn't give the full thread specs in the name or description (I didn't have a Honda) but it worked perfectly. Good quality construction. In case you are wondering, the full spec is 12mmx1.5mm (Fine Thread Pitch) and I installed this oil changing aid on a Powerland PD3G10000E Tri-fuel Generator.

Very straightforward install. Installed on GX390 powered generator. A big time and mess saver for oil changes. Just like many others I wish I would of bought this sooner!

The positioning on my particular mower makes it a little difficult to remove and install. But even just using a crows foot to install this part, I was able to install it and it has not leaked. Works as it should.

Works great on my Brave 20-ton log splitter with the Honda GC160 engine. The hose is made of a good quality rubber with all brass fittings. It would be nice if Drainzit included some recommended torque specs, but I tightened it down nice and tight and so far no leaks!