2 Pack Of Polished Brass 1-1/2" Round Flush Ring Pulls, Made Of Solid Brass By QCAA Review

Got these for our pull out spice rack. The ring was a little small but it fit flush against the cabinet and looks beautiful. It is very well made and will definitely hold up well over time.

I bought the satin nickel. Good quality, thick and sturdy. The size of the round finger tip part is 28.9 mm in diameter. So I drilled the initial hole with a 30 mm Forster bit and than had to do the remaining work with a chisel . Took about 30 minutes.

If you need to install these flush you need to drill portion of the wood or backing as the back is curved and need to notch the wood at top of the ring to have the device seat flush.Over all it works.!

This was just what I was looking for as a replacement. The ring pull works great, The only thing I wish is the ring was a little thicker make it easier to pull.

A little smaller than I expected it to be, but that is not the fault of the product. I would go with a larger one another time, but this does what it is intended to do.

I built a new bench with hinged seats and although the ring pulls are a bit thin, I wanted them to be flush with the surface. Once I created the recessed space and secured them with the screws they come with, they work perfectly. They are solid and not of cheap material. The ring pulls up easily and the ring is solid and smooth. The hinge works perfectly and the ring drops back into the hole as soon as you let go. The whole piece is made of quality material and looks fantastic.

Perfect solution to replace the broken hardware on my window bench seats. You'll need a chisel and some patience to install but it's worth the effort.

Liked the fact that these flush mount pull rings were very sturdy and worked great on the crawl space covers in our home. The floors were hardwood and these worked perfectly.

Had to buy a small latch for the trap door in my living room to be able to use it. It is a very heavy door but despite this, the latch has surprisingly remained strong despite it's small size

It was the perfect knob for the tight drawer inside the closet. The closet door was too close to the sliding closet door and unable to slide. The flush ring pull was the solution.

Exactly what I expected. Looks great. Only negative is the screws are soft metal. Be gentle, strip easy. That's my review!

This drawer pull seemed good and solid but it was not what I wanted so I returned. It. Could be used for a small drawer but nothing more.

I love this thing but, it says FLUSH but you you have to to counter sink it to be flush. Kind of a pain cuz you have to carve out a bit of the wood to give the ring plate room to sink and the front plate to mount flush….will report back after install!

This pull is brass with a spray painted flat black finish. When closed all visible surfaces are flat black, but when you lift the pull the original brass color is obvious. Whoever sprayed the flat black did not lift the handle to spray underneath. Be prepared to do some flat black touch-up.

I needed a larger ring like this in matte black for a door that I wanted to match with the pull rings I put on my cabinets. Unfortunately, this was not matte black. It was more of a satin finish, so it did not match my other hardware.

It shows two products when you buy them but you only get one product I would have kept searching for a cheaper price for two if I knew this one piece of information!

We flush mounted them. They look fantastic. High quality, easy install. We're very happy with this purchase. Highly recommend. Thank you.

I was looking for a flat, flush pull bracket for a crawl space cover. The description on this one gave me the impression I didn’t need an inset in the floor. It’s 1/4 inch off the floor. Returning.

The ring on these was a bit too small to use a finger to open the latch unless you have very slender fingers. Value for Money.