🚲 RAD Cycle Mighty Rack: Ultimate 2-Bike Floor Stand for Instant Versatile Pro Quality Bike Parking Review

I appreciate the caution about your tire size before planning to use this bike. I ordered it and it just fits our bikes. The instructions on the box gave three different types of screws and they only came in two sizes, but they were enough to put this together. The design problem is that the tip of the screw goes into the recess. You can barely use the small included wrench around the edge of the top to tighten it. However, it has evolved quite quickly and appears to be long-lived. I was happy…

The bike stand was well packaged and all parts were present. Instructions were simple and assembly was relatively easy. My problem was that the bike stand could not be used with my disc brake bike. It is possible for this kickstand to work with larger circumference tires as the outside of the tire makes contact with the top of the kickstand and prevents the bike from digging deeper into the kickstand frame. But on my bike with 700 x 28 tires, the wheels go too far into the frame of the stand…

I spent the day looking forward to the arrival of my bike rack. And then, the day he arrived, I felt like my whole life was over! Once I assembled the tubes and made sure all the fasteners were tight, I was able to stow my beautiful neon green Mountain car. So it sat there, rocking onto the podium's chest. My bike no longer needed to use the stand and since this stand is designed for two bikes I was able to place my Pee-Wee Herman Cruiser right next to it for added dramatic effect…

FYI I'm mechanically inclined - I build for a living. This bike rack is everything you think of when you hear "Made in China". The list of small parts described does not match the scope of delivery. There are no long and short bolts, they are all the same length. It says that you need a "standard key" for assembly. No, you need a size 10 socket with an extension and a ratchet. I assembled the frame according to the instructions and found the center bar to be too short. I had to disassemble and…

After reading all the negative reviews I almost decided not to buy this shelf. I'm so glad I bought it. It comes with instructions and they were helpful. In general, it took me no more than 30 minutes to assemble this rack. All parts were in the box. All screws were in a plastic bag. All the screws fit easily into the parts as described. As I said in the title. IGNORE ALL NEGATIVE FEEDBACKS. It was very easy to assemble. I assembled it in a side by side configuration. There were other options…

Wheel spacing is 2.5" wide so will fit most, but not all, mountain bike tires. Bikes with narrow 1" tires then you will need to add padding to keep the bikes from tipping over - styrofoam water pipe insulation will do. A big plus is that when the backrest rests against the wall, the rear wheel of the bike does not touch the wall when installed in the trunk. On many bike racks, the tire will protrude from the rack and will most likely slide off when the bike is in use. a stamped piece of metal…