🚀 High Performance 4-inch Cold Air Intake System with Heat Shield for 2009-2014 Silverado 1500, GMC Sierra 1500, Yukon and Cadillac Escalade ESV EXT (Silver Tube & Black Filter) Review

inlet works, maf built without any problems. The clips are very cheap so I had to buy new ones, the ones in the kit broke right away.

I haven't noticed much, if any, increase in mileage. This allows you to hear the powerful draft that the engine makes when downshifting. But still better than stock

After a long and tedious installation. And 4 trips to the hardware store, it's installed. Missing equipment. The main melody was kinked. Connection for inline air mass meter. The locking screws were knocked out. Absence. If I knew that, I would build it myself. Rschunimagu. Do not do that!

The goods arrived well packaged. Looks good, was easy to install after some research on the internet. Installation instructions must accompany the product. I had to buy 2 extra clamps that were not included. Overall I am very happy with my purchase.

When I ordered I was nervous because of the price, there were no instructions in the kit but I watched the video on YouTube and everything was fine, it takes a little effort to close everything fit . But after everything was installed I was very happy I gave my 2010 Silverado a dealer sound in the exhaust and a little more power, if you're looking for intake and not trying to pay with hand and foot I'd certainly give an obvious one Recommend well known brand it will give you a bit more but it's

I have a GMC Sierra work truck, 4.8L V8. I was pleasantly surprised by its weight. I was expecting some plastic parts, but all the main parts were good metal with nice finishes. Installation was easy, found a youtube video with another one slightly more expensive but very similar. I saw where some said it was a bit big, despite what it looked like I had no problem closing the hood. I have a few concerns about how open it is and I might plan to close off the bottom where the original filter is…

Installation is as easy as any other cold air kit, however this kit comes with no instructions and includes some special parts so be prepared to spend some time with it. The clips worked but I don't like them as they hit the bottom and still feel like there is room to move. I like to feel a little resistance when I reach optimal tension, I just feel like they might slip. The heat shield is too high and had to be tilted forward to close the hood. I checked twice to make sure it was installed…

I thought I could save a few bucks for my wife's truck. The overall quality of the materials is no better or worse than other cheap tea sets. There are no instructions. Fit only air duct for 2011 Escalade 6.2L. The heat shield extends beyond the hood line and prevents the hood from being closed without damaging the lining or the hood. You'll have to cut back on what I half expected from someone's off-road install review. Pretty sure it was designed for the hood of a truck. Another install guide

Wondering if these blocks are going to be expensive and of high quality, then you found out that the part of the thermal block (which holds the whole block in the engine compartment) is too high and you can' close the Bonnet not flush (on the right the bonnet (passenger side) is lifted off the top of the heat box protector. I even tried removing the rubber grommet to make more room but no luck, I also tried using a rubber mallet to knock it down , tried bending it, still nothing. Metal to about