🔌 High-Quality 4-Gang 12V Rocker Switch Box for Auto Automotive Lights, Marine, Truck & More - 20 Amp Max., 12 AWG Wires, 12 Volt DC Review

Easy to install even with my near zero electrical knowledge I was able to find some videos and install this easily. The box is simple and pre-assembled. It's aluminum so not cheap plastic and the wires used were good quality too. I can highly recommend the product.

We bought these switches to control a farm tractor's electronics (GPS, sprayer controls etc.). The box is higher quality than we expected, the switches were reliable and the indicator lights already saved us from battery drain. The wires are marked with a switch for easy installation.

Perfect for supplemental power and lighting in my UTV/SxS. Mounted under the roof, I've used it to distribute power to a front mounted 32" LED bar, two rear LED bars, a small LED courtesy light, and as an on/off switch for my UHF/FRS radio . It ran on a #12 wire powered from a battery post and had a built in main fuse.

This junction box is well built and compact in size for a 4 gang junction box. Installation was easy: the 12 ga input and 14 ga output wiring should easily handle a total load of 40 amps, or 20 amps per circuit (switch). Just remember that 2 switches for max (20 amps) is the total draw of the junction box, if you want to run 3 or 4 circuits at once you may need a relay.

I use it as an emergency light control. The device feels solid and is easy to install and connect. I expect this to last a long time. I am satisfied with the product. I probably voided any warranty for opening up the device to add a momentary contact switch, but ascII said it was a reliable device and any warranty was irrelevant. I would buy one or more without hesitation.

This module connected to two LED high beam headlights which were connected to a 4 amp fuse for each headlight. It also had dual lighted antennas that used less power than high beam headlights. Within five minutes the module failed and not a single fuse blew! This is my second. The first sits under the hood of my Jeep and connects to three small LED lights to illuminate the engine bay when I need to work on it at night. They haven't been turned on for more than 30 seconds since I installed them.

Very reliable device. It is correctly assembled and easily disassembled. Robust housing and reliable switches. Easy to assemble and install. I had to take mine apart, change the wire connections so that the switches connect to ground or power instead so I can use the relay in my custom application, but there's no way you need that. Doing this gives you enough room to add extra wires and more LEDs if needed. I added 5 LEDs for my methanol system and there is room for more in this box. The…