🔧 Ultimate Corner Clamping Solution: 8-Inch Deep Throat U Clamp Review

So far so good. I bought two of these to make my bench grinder mobile because I have 3 of them (one for grinding, one for sharpening). knives/axes etc and one for polishing) - so when I need a grinder in my garage each bolts to a 3ft wide and 8 inch deep piece of plywood - that's why I needed them - and they hold each grinder with no vibration or otherwise Noise on the spot - just stick a piece of black electrical tape on the tensioning mechanism just in case, depending on the situation, a…

This clamp was exactly what I was looking for. I've ordered various things lately and when I open the package they are less than half of what I pictured in the pictures. This U clamp was the opposite. It was more than I expected which was a big surprise. The finish of the clamp body is nice and comfortable. It lies well in the hand and makes a robust impression. The only downside is that the yoke is a bit crooked, like it has a curve in the body. When I screw the clamp all the way in, the hinge

I bought two of these clamps for a woodworking project. One was fine; the second had a curved mating surface at the point where the turntable on the screw shaft makes contact with the clamp body. It was enough that I was worried it would mark if I tightened the clamp hard enough. Instead of dealing with a return postage I went to the local shipping port to ship it back. They were very helpful and exchanged it without asking questions. However, of the two replacement clamps I saw available, one…