🔧 AccusizeTools GA41 0050 Precision Toolmakers Insert Review

a little disappointed, not sure if I received a defective product, fixed jaw and body were parallel but movable jaw was not parallel and was smaller than the width of the bit, the fixed one Jaw and body width is 25.90mm while movable jaw is 25.50mm wide, everything else is fine, no sharp edges or burrs to clean

I am a tool and die maker by trade and needed to replace another mini grinding vise that was poorly made. This vise does what I need and seems to hold pretty well and accurately. I would recommend it to someone who needs one of these without spending over a hundred dollars. The vise has a ribbed plastic body similar to that supplied with the end mill.

This vise needs improvement. In general, the vise is good. in specification for squareness and the finish is very good. The biggest problem is the clamping screw. I made a small batch of parts and after about 20 uses the hex head of the screw started to peel off. I made sure I had a well fitting hex key (one not included). The screw is tapered, so it cannot be replaced with a regular head screw. I haven't decided yet whether to keep it or send it back. I have a few days to decide.