🔑 GM Genuine Parts D1462G Ignition Lock Housing: Ensuring Reliable Ignition for Your Vehicle Review

Black plastic on one end, on the other end containing the ignition switch. the opposite end (using a screwdriver or similar) to simulate inserting and turning a key to loosen the black plastic. I did this by crouching with one knee against the wall for balance, placing the housing between my knees (so my hands were free), and then using a screwdriver to push the spring-loaded piece in the center of the ignition switch housing and twist the locking mechanisms. This may be confusing, but the gist

2010 Colorado. When I accidentally left the door open when attempting to start, I was blocked for 10 minutes. Then last week it happened with the door closed but the window open (could it be a coincidence?). After a determined search I found this and decided it was worth the risk. I only swapped the switch, not the whole case. I went through the process of retraining, but it didn't work. I searched and found similar instructions but nothing good. Postponed a few days. Today I tried again and it

I had to reprogram it 6 times to get it to start, so don't give up. I found this procedure on the internet. Reprogramming the system - step by step Step 1 - Try to start the car. Runs but doesn't run. The security indicator flashes on and off. Leave the key in the "work" position for exactly 10 minutes, then the security indicator will turn on or off. Step 2 - Turn the key to the off position for 10 seconds. Try to start the car. Some vehicles will work at this point, but many will require you…