AOOTF Real Carbon Fiber License Plate Frame with Black Gloss Finish - 1 Piece, 2-Hole Design, Car Tag Aluminum Frame and Stainless Steel Screws, Carbon Fiber Pattern Caps and Anti-Rattle Foam Pad Review

The license plate holder is very nice and keeps the number safe. A real plus was the pad that had to be placed at the back to avoid re-tailing. My car uses very long bolts and when contacted they immediately sent me longer bolts. Good service.

Looks great but screws don't fit front or back. I've used other screws and everything worked fine except for two caps that didn't fit the bag ring snugly. I emailed the seller/posted a question about Revain but there was no response for about a week and a half.

Sturdy and well made. It fits well and looks great. I'm a fan of not writing on my cymbal frames and I prefer clean lines. This carbon fiber frame is just the ticket. It's been on my new car for a few weeks now, despite tons of rain and sun, and it's holding up really well so far.

Really good plate frame but the screw caps are difficult to remove if you need to remove the plate from the car after installation. I changed the number plates so this had to be erased. reach the locking screw below. so I had to reinstall without the protective cap.

When ordering remember when ordering - the ones in the photo are chrome plated the ones I received are white. Can make a big difference. I'm not sure if I'll even get them in chrome. EDIT: I'm an idiot. I opened them from their plastic packaging and found they were just a protective sheet to protect the chrome. derp Good product.

I bought this frame for my new car but it has some issues which I have listed below. 1- Installation instructions do not match this frame. The parts are different. For example; Package with nuts but no installation instructions. In addition, washers are indicated in the installation instructions, but the packaging contains these and other items that also differ from those described in the installation instructions, e.g. B. a shock absorber, not. The screw holes do not line up correctly with the

It is almost impossible to remove the anti-theft pads from the screws after installation. I think that's the point but one wasn't quite tight and rattled and after much frustration my friend was finally able to take it off and was very unhappy. Just be aware that they are HARD to remove. If you never want to delete them, that's great. Just make sure you tighten them as tight as you like before putting the caps on. Although the lids of the plates are shiny and beautiful. I didn't use the screw…

Screws included too short for the top and too long for the bottom of the frame when attaching to the license plate! To clarify, the anti-rattle foam backing is nice and fits nicely on the back of the license plate and will certainly prevent rattle. However, the upper screws are too short and cannot grip/reach/attach to the vehicle! Also, the bottom screws are about 1/2 inch too long after securing them with the included hex nut, which can scratch my paintwork. A plastic cap would be nice. After

Product well made but poorly designed. I purchased this item a few months ago (and can't return it) while waiting to receive new custom license plates from NJ DMV. The plates arrived earlier this week (we're talking slow service!) and I set them up with a holder. Yesterday I was stopped by the police because my number plate was sealed. It is illegal in the state of New Jersey to conceal lettering on the plate this holder makes at the top and bottom. You can't deny the charge — the inscription…