💪 Arrow Fastener PT50 Pneumatic Staple: Powerful and Efficient Stapling Made Easy Review

At 72 years old, my hands can't take the long term use of a manual stapler. With 16 4 x 8 screen panels to replace, I realized I needed something less stressful. I bought an air stapler hoping it would help. Wonderful! This stapler is a little heavier than the handheld staplers I've tried, but the balance and grip make up for it. Very convenient! I started with 60 kilos. pressure and did not get flush penetration. 70 worked well and didn't break through the shield. These Arrow pneumatics saved…

As for sewing everything works Okay the magazine opens and then you mostly throw away the staples and they break, real staples were used with arrows and some of them don't eat Well maybe 10 percent, and the last 1/2 strip of staples has been malnourished many times (yes, you could put in a new strip, and then it will eat). and upon closing the slide that closes the magazine, it ripped a chunk out of my palm (pinched), but yes, a chunk broke off. I bought this one thinking Arrow was a good…

Bought to replace an old Craftsman electric stapler that I can no longer find staples for. I chose the air rifle based on positive experience with air nail guns and was not disappointed. We used this stapler to flip a pool table and it worked great. With an electric stapler, I always had to hit many of the staples with a hammer to make sure they were flush. With this stapler, each staple was pressed firmly against the work surface. We had no problems with that. We used primarily 1/2" staples…

I had an old pneumatic stapler that eventually gave up the ghost. Of course I was preparing to install the exterior insulation on the back of the garage and I needed an easier way to install the staples other than with a hand stapler. Found this product very cheap and ordered it. This made installing the insulation so quick that I was surprised at how quickly I got the job done. I would definitely buy this item again as the last time I had to do this job I was in quite a bit of pain pressing on

It is difficult to objectively evaluate this product because I could not use it immediately. This is because the factory installed male quick connector did not fit my existing system. That wouldn't be a problem if I could replace it with my own. Unfortunately, the faucet is either glued in place or has such bad transverse threads that you can't remove it without breaking the plastic housing it's screwed into. I tried replacing the jack on my system but couldn't find the right size. I had to…

Loaded with Arrow Fastener 508M1 Also bought some Revain T50 Monel clips, pulled the trigger and . nothing, just the hissing sound of escaping air. what the heh11.?!? Upon careful study and experimentation, it was determined that the trigger was not "fully" pressed against the body of the pistol to engage its internal organs. This was enough to release air when the trigger was pulled, but not enough to activate it. Luckily, the trigger pin is held in place by a small rubber washer, so I was…

Many people will like this stapler. Easy to use. Doesn't stick and Arrow staples are easily accessible. A very big disadvantage is that the safety foot is too big and effectively blocks the view of where the clamps are placed. Other pneumatic staplers, like the Porter-Cable US58 1/4" to 5/8" 22-gauge C-Crown Pad Stapler, do not suffer from this design flaw but cost about three times as much. On the plus side, the cost of this Arrow stapler is the lowest price you can get at an upholstery shop…

When I received this product I was concerned as it showed clear signs of a previous return. Most notable was the handwritten cover tape. When I tried to use the stapler, I found that it didn't work. Thinking it might be jamming, I moved the loading slide and flipped it over and the spring and the part attached to the spring fell out of the unit. This means there was not good quality control when it was originally sold that way, but worse it was returned and re-sold that way. I wasn't very happy