Ryobi Battery Holder: Efficient 18V Battery Storage and Wall Mount Solution Review

This battery holder is well made, attractive and works as intended. The only downside is that it costs about 4 times what it should be.

Definitely glad I tried it. Works perfectly, setup takes less than 5 minutes. I also learned that this is a small private company. Look, you will be satisfied.

It runs on three 18v Ryobi batteries and failed and broke after three months of normal use. I like the idea so I'll look into another battery organizer but not made out of cheap 3D plastic.

I like it, but I have a few recommendations. Thanks for turning on the hardware! If it was $12.99 I would buy 2, $17.99 - it's a bit pricey. A few design tips - I cut my finger unboxing, the edges are sharp. A bit of sandpaper around the edges very quickly after you take it out of the printer would be great, or maybe the design could round out the edges? On the back of the screw hole, the part that faces the wall, it would also be great if you could make the hole slightly larger than the size…