🚗 Eldwviz Car Engine Start Push Button Switch Ignition Starter Kit Blue LED Universal - 12V Power & Convenience for Your Vehicle Review

Here is the instruction I used after using the counter on the switch and relay. A typical ignition switch has four positions: 1=off, 2=accessory, 3=ignition, 4=start. The relay has 4 wires 2 blue, 1 red, 1 black, instructions 1. Click on the @ terminal of the ignition switch, which has 12 volts when the key is in the ignition position with only 1 red and 1 blue.2. Locate the ignition switch lead @, which only has 12 volts when the ignition key is in the start position, and cut this lead at the…

Works but the instructions are in Japanese so you don't know which wires go where so I will help you. 1st blue wire - ignition input, 2nd - ignition output, black - ground, red - 12V power supply when the key is on. Black and red are for the backlight and blue is for the actual ignition switch. I recommend looking at your car's wiring diagram for the actual wires as well as the wiring in the fuse for the ignition wire. So if it ever gets overloaded, the fuse will blow instead of burning your…

This product has been on sale for over 6-7 years... I assumed it was a good product as it is still on sale. I read reviews after my problems and bam! Everyone has the same problems! It worked a couple of times after I installed and checked before pulling it up...after pulling it up the car started twice and after that the relay doesn't work anymore and there is no way to bypass the relay.. .it can't be changed by just skipping it to use the button...nothing! Don't waste your time...it doesn't…

It works exactly as the seller says. Make sure you can read the wiring harness for your vehicle. This was my first time modifying the wiring in my 2003 Mustang, but I was able to figure it out by doing a bit of YouTube research and reading the spark plug harness wiring for my car. All this to say that I would not buy this item to start my car unless my ignition had a steering column problem which would have cost much more to fix than this bypass. In the end I would recommend it if you really…

This starter button switch works very well so it fits my 2006 Ford Mustang GT. I was very concerned by some of the negative reviews I read about this product. It didn't cost much so I decided to give it a try. Most instructions are in Chinese. There is a small section in English but poorly explained. The knob is all plastic and the adjusting nut does not over tighten. The relay has 4 wires (red, black and 2 blue). How to install (connect the red wire and one blue wire together, then connect it…

Worked well to work around a problem somewhere in my ignition system. I installed the button in place of one of the cigarette lighters, eliminating the need to dismantle the steering wheel and splice the wires. Then a cable through the firewall and straight to the starter. The button only lights up when you press it. That's how I connected it. The output wires were red blue black black. I connected the red and blue wires to the red wire that powered the cigarette lighter. I attached the…