🪚 Tungsten Carbide Diameter Grinding Tool for Carving Work Review

I needed a strong drill to drill through a 1/2 inch screw. I've done a little research on tungsten and while tungsten is strong it can break easily so proper handling of this drill bit is crucial. After forgetting these bits, I only managed to break two from mishandling and surprisingly the bits just didn't wear out on me. I was able to finish my project (that was my last hope) and it worked! The bits were smaller than I thought but turned out to be very strong and wear resistant

As you can see from the photos I have provided the carving has my name on a piece of wood damaged the round ridge so badly. Which ended up happening because I haven't actually used those cents for fear of ruining them. It's like I'm saving them for a special project. However, I am very disappointed with the quality, they say that tungsten can cut metal without any problems. You wouldn't believe wood carving would fail completely.

I bought these to get a broken exhaust bolt out of the engine. I also broke the extractor on the bolt. I had a goal for her to get that bolt out. They worked! Variable speed Dremel tool, patience and that little set of carbide cutters slowly and carefully not to hit the aluminum where the screw broke. Yes, it took time, but they grind hard metal. After work I tried a piece of wood, then fiberglass, no problem. They didn't dull or break. Good tools.