🗿 CNC Carving 5.26 Degree 2 Flutes Tapered Angle Ball Tip, 0.25mm Radius, 1/4" Shank Tungsten Solid Carbide, HRC55 with TiAIN Coating Review

This bit allows me to do so much detail that the results are unrealistic. I'm no longer limited by the diameter of the racquet, I'm only limited by my design skills.

I use this bit to put my name and personal drawing on my AR builds. The letters in the picture with my name are 2.5mm tall, the pin on the bottom right is 4mm (5/32") tall for comparison. I bought three bits and am still using the first one after 2 builds that too Have magazine well drawings (second photo).

It's a good piece of 6, but if you do a lot of 3D/2.5 threading you're better off with the more expensive one (Amana). After 10 cuts, for example, the dentition becomes doll-like and the color, which cannot be called a coating, disappears. It's not a problem, but nobody needs a puppet punch. So not bad for the price, but if you do more 3D then go for the best.