Darice 3.25 x 8 Inches Airbrush Stand - Convenient Holder for Airbrushing Tasks Review

This is a heavy duty airbrush holder. It's a clamp for the deal, so you'll need room to clamp it. You can't just put it on the table. But I can't remember an airbrush holder not sticking to something. I usually run 2 brushes and this unit is pretty stable even with 2 brushes hanging on it. The hooks themselves are covered with a subtle rubber coating. They had to be spread a bit to fit the Paasche VLS, but my narrow VJR fitted snugly. There are also 2 durable plastic holders for narrow brushes.

I rarely write reviews but I've seen a holder very similar to this one. The one I received has no rubber on the bottom screw head. The base is plastic, not rubber-coated metal. The metal part "c" is not attached to the base. The top two brush holders are attached to a metal rod that slides into a cylinder at the base. It's fairly standard, but this version doesn't have a locating pin to hold it in place. So this thing moves when you try to use it and falls out all the time when you move it. I…

The clamp part is the only thing I like about this holder. The overall design is reasonable but once the plastic base breaks I will end up modifying it to make it how it should be. I have a Paasche H type airbrush and I find this holder best suited for the following modifications: 1. The rod holding the airbrush wire holder is too short in my opinion. It needs to be at least 1 inch longer to work properly with my brush. However, I would prefer it to be at least 2-3 inches longer. The same rod…