🔌 DHT Electronics Industrial Electrical and Wiring & Connecting Coaxial Adapter - Female Review

The high quality connector is great for cable management in tight spaces behind the radio and prevents it from twisting.

Won't snap into place, after mounting it on the radio and attaching the antenna instead of holding the antenna straight at a 90 degree angle it just rotates and falls down descent. complete crap!

Installed my CB on my Jeep JK and found the air ducts do not allow normal wire connection into the radio area. It worked and now my CB and radio of the same height fit perfectly.

Used 4 pcs. for installing polyphase transformers in an external connection box for 2 antenna coaxial cables. With a polyphaser and two of these, the return loss was less than 0.05dB on HF, 0.1dB on VHF and 0.2dB on 450MHz, so anything below 70cm wouldn't even be noticeable.

I received the product and even before I opened the package, the back said "internal short circuit error", it was a sealed package so I decided to open it and when I checked it turned out that of course she was being bad I guess no one can read the delivery department.

I needed this because space behind my IC-7300 is limited and connecting the cable directly would strain the connection. It had good reviews and works well for my purposes. Some others didn't have high ratings. This one seems to be of good quality and I haven't noticed any signal degradation when using it.

I needed this because space behind my IC-7300 is limited and connecting the cable directly puts strain on the connection. It had good reviews and works well for my purposes. Some others didn't have high ratings. This one seems to be of good quality and I haven't noticed any signal degradation when using it.

This product will help you get out of those hard to reach places. Transceiver cable connectors are often placed in awkward places, e.g. B. on the back if you need to route the cable straight down, right or left. The connector may be on the side and you need to route the cable through the back. In such cases you really need a rectangular adapter and this is it. It is nickel plated, well made and durable. Look no further for solutions.

Yes, it does exactly what it says on the tin. This is a PL-259 SO-239 Right Angle Connector that really gave me a much needed right angle twist. Is it expensive for what it is? I mean, yes, probably most of the cost is shipping, and if you're lucky enough to have a ham shop nearby, you'll save the $2 you lose on shipping by buying this part online. But if you don't, I'm not sure it actually gets cheaper for anything. To clarify: SO-239 is the default connection to PL-259. If you're new to…