🏷️ Sanford Brands 1756589 RHINO 5200 Label Printer Kit: Efficient Label Printing Solution for Professionals Review

At first I was very satisfied with the DYMO Industrial RHINO 5200 labeller; I worked as advertised and allowed myself to complete my wiring project with neatly printed labels. The reason for the 1 star is that the display has stopped working, you may see a yellow backlight but no text or lines of any kind are shown. The device was only used for one project, it was stored in a suitcase in an air-conditioned computer room. I've tried all the options in the troubleshooting part of the manual, I've

That's pretty good for a little sample. I was very concerned about the amount of waste as I have had labellers in the past which were very wasteful. This label printer is small, efficient with buttons and an easy to read display. It is very pleasant that the label printer charges the supplied battery. I chose to charge it with 6 batteries and leave the included battery as a backup. My only criticism is the labeller's inability to determine the tape size of the cassette. I would add a few…

I've never used a label printer since I was young and could only afford an old clicker. My wife bought a DYMO 160 for her home on sale at Home Depot and we love it. Being pretty good at woodworking and metalworking, I decided to buy a Rhino 5200 and, as they say, go all out :) I really like this big baby. It can do pretty much everything I can dream up and then some. So far I've used it to label the electrical panels of my home and store, I use it to label audio cables for my stereos and home…

I bought a Dymo Rhino 5200 after seeing a Bigclive review on YouTube. There's a lot of good and very little bad in that. The Good: The labels this printer uses have a laminate on the label, making them much stronger than the inexpensive DYMO label printer I've used for years. . Also - and I can't stress enough how much of a difference this makes - there is a slit in the middle of the back of each label. The separation makes it very easy to remove the label liner - one of the most difficult…

I work in IT and electronics. I have lots of wires, settings, components and more that need to be marked. For 2 decades, my trusted label printer "brother" worked fine, but there were many problems. Fonts, for one, can't write ohms, superscripts, or much more outside of traditional AZ, and even if a character is there, it's hard to find unless you use it a lot. I also had to be very careful to make sure the settings were set correctly. I was looking for a better solution and came across DYMO…