Invisible DIY Electronic Cabinet Lock Kit with USB Cable - Hidden Lock Set for Wooden Cabinets, Drawers, Pantries, and Lockers - RFID Entry Review

It was easy enough to install and pretty easy to program. The smaller tabs go through 1" plywood, but I have to move slowly and get closer. The card works fine. Not sure, the lock is brittle, and one side attached to a flat surface with four screws actually only holds about 1/4 inch threads. It can also be opened with a strong screwdriver. With a nail it becomes child's play. I put it on the table which is a box and actually has a hinge. I had no problem with just pulling on the top and prying…

I gave 3 stars for the installation because it requires some work and it is CRUCIAL that you install the batteries before you close your cabinet. There is no way to open it any other way. I messed it up and had to cut a hole in my closet (you won't find it) so we can install the batteries so I can get back in. Totally MY fault but you should be aware. Set it a little lower. than you see fit - the locking tongue is quite high. MAKE SURE YOU INSERT BATTERIES BEFORE CLOSE. Love the card key, am…

Advance - "Instructions" does not work. He never says "dee-dee-dee" or "didi-didi-didi-didi-didi" so multiple keys can be used. Works with one key and that's it. If you lose the key, you're screwed and have to open the closet, ruining your furniture. If the batteries run out, you're done. You have to cut it out and thereby ruin your furniture. There are no installation steps. It says "use double-sided tape". That's all. Absolute JOKE! The screws that came with it are absolute rubbish. They…

Works great! Very easy to install. Don't listen to reviews that are difficult to install or configure. The secret is to use strong 3M double-sided automotive molding tape (available at most hardware stores). Measure where you think it should be. Then tape the two pieces in their respective places and see if they fit together. Unless. The band allows you to adjust. When you find the perfect place and everything fits. Use screws and secure the lock and latch. The tape does not need to be removed.

Great idea, bad execution. Didn't work right away with new Duracells. I tried another brand of battery, it seems to work. Before the final installation I checked several times, everything seems fine. After installation it still worked perfectly, but after 2 days the device stopped working and my cabinet wouldn't open. Luckily it's just cheap plastic so it was very easy to open but it still damaged my closet. The literature says that when the batteries get low it defaults to the unlocked…

Where to start. First of all, we strongly advise against buying this junk. First of all, I'm a very good carpenter and builder, but assembly is extremely difficult. No templates or sizing are provided, and the lock doesn't line up naturally with the pin, so you'll have to offset or misplace them by a fraction of an inch, even with flush mounts. And when you consider that most kitchen cabinets have indentations on the inside, that makes leveling even more impossible. want these! When you finally

Arrived fairly quickly and exactly as advertised. Now for the specifics, there were 3 cards and 3 keychains in the kit. There is no reset button where it says it should be (just a hole with nothing in it) but when I turned the lock on it immediately beeped 'ready to pair' and I was able to get all the cards and keyrings on the first try with no problem couple. In the event of a power failure (battery dead and not plugged in) the lock STAYS LOCKED which isn't a problem for me personally as it's…

Cool gadget. I was looking for ways to enclose tools and electronics in a dorm room. Bought some ottomans and thought they looked a lot funnier than key locks. Bought two sets to test. Each came with three cards and three keychains. I bought batteries (separately), installed a master key fob and added the same two locks. Very easy to program, I quickly added all the cards and fobs to control both locks. After playing with it for a while, we decided to install it. There were no instructions, but

I like the lock. I wanted to install it in the bottom drawer of my bedside table, I didn't even try to install it in the top drawer. I also removed the top drawer so I can see what I'm doing. I have a bedside table with space above the drawer, it is not flush, this lock is perfect for that. So I had to modify it a bit to make it work for me. First I installed the battery box in the drawer, making sure I set it as high as possible while clearing the horizontal drawer support beam that separates…