🔧 ENOMAKER Near Ender: Optimal Direct Extruder for Enhanced Precision Review

The device was easy to install on the Ender 3 Pro and I am very happy with the results. Everything you need is packed in a box, disassembled and packed in a way that no small parts are lost. The backplate came pre-assembled, all that was left to do was tighten the screws and adjust the clearance. The hot end connector was straight and the included blue tubing was square and didn't need to be cut. Installing the extruder took a bit, but only because I wanted to use black (while staying in color)

You're spending almost the same amount just to get an aluminum extruder, extension cord and spare wheels so the actual direct drive upgrade really works as advertised becomes . it is not relevant. However, it works. From a near-standard Ender 3, I get consistent quality at speeds around 100mm/s or higher, and the pullback is amazing. I haven't had much luck with the Bowden setup, but I haven't had any jams since installing it. Those are the pros, the only cons I can think of is the weight of…

I was very happy with this purchase. (READ LAST SECTION IF YOU HAVE PRINTING PROBLEMS) My Bowden tube is popping out during printing or something is stuck inside. I was pleased with the easy installation. If you have experience building a printer (my Ender 3 Pro came unassembled) you should be more than capable of building one. My only recommendation is to think about wiring before installing a stepper motor. If you install the wires on the right side (screen) it sounds like you have what…