Header banner
Revain logoHome Page
2-pack genssi 50w led bulb fast flash load resistor hid kit - enhanced seo logo

2-Pack GENSSI 50W LED Bulb Fast Flash Load Resistor HID Kit - Enhanced SEO Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🧯 Ignition Parts, 🛠️ Replacement Parts

View on AmazonView on ЯM

Media

(1)
img 1 attached to 2-Pack GENSSI 50W LED Bulb Fast Flash Load Resistor HID Kit - Enhanced SEO

Description of 2-Pack GENSSI 50W LED Bulb Fast Flash Load Resistor HID Kit - Enhanced SEO

One resistor is required for each turn signal bulb or headlight plug; Installation is simple; just connect one wire of the resistor to the ground and the other one to the positive wire; The Resistor should run parallel to each other. Designed to be installed with HID kits that flicker and cause dash light out warnings. High working temperature; Do not mount on plastics. This will solve LED related turn signal problems such as hyper flashing, no flashing or burnt out bulb indications. Pack of 2; Includes 2 resistors.

Reviews

Global ratings 3
  • 5
    1
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Works as advertised but make sure they get very hot.

I bought these to keep the high beam LEDs from flickering when not on. The flickering is caused by electrical current that the controller uses to determine if the bulbs are working, but I don't use bulbs. They have stopped flickering as advertised but do get very hot and require mounting to a metal surface. It's wise to find a nice flat metal surface with plenty of area to radiate heat and use thermal paste for additional heat conduction.

Pros
  • High operating temperature; Do not mount on plastic
Cons
  • Only available in black

Revainrating 4 out of 5

Hooray, I have normal turn signals again!

They worked great to get my LED turn signals blinking at normal speed again! I first determined plus and minus for each front turn signal with a voltmeter. . I connected the red lead to the positive turn signal lead and the black lead to the negative turn signal lead using the supplied clamps, then attached them to a nearby metal support with 3m double-sided supertape. It took maybe 30 minutes total but I like to get things right and not rush. Other reviews say they get hot but honestly I left…

Pros
  • 2 pcs. packed up; Includes 2 resistors
Cons
  • Safety

Revainrating 4 out of 5

Great price and still works well

I installed these resistors on my xenon headlights today and so far so good. I connected them in parallel to ground and positive wires. Basically, one end goes to each of the - and + wires. I haven't checked the flicker issue because I'm waiting for it to get dark. But they work as long as voltage flows through them. For the price, this offer is unbeatable! Although they are very HOT. I mean, 2nd degree burns hot! The way I installed them, they hang freely in the air (under the hood of course)…

Pros
  • This solves LED turn signal problems such as excessive flashing, no flashing or showing a burnt bulb
Cons
  • Update available