🔩 Grizzly G6811 2 Inch Diameter Screw Review

The die is not properly seated in the handle. Poor quality remaining screws. replaced the mounting screws, the die is still not seated properly. could not use the product. I would have expected better quality considering it is used for cutting gun barrels.

This stock holder places the face of the ram flush with the stock holder allowing you to thread much closer to the base of the front sight when threading rifle muzzles. On some other dies, the cutting edge can be positioned under the edge of the part holding the cutting edge, allowing it to rest on the underside of the tool surface before the thread is fully cut. There is no problem with this tool as it allows the die to be completely cut until the die itself touches the FSB. I will recommend…

Not as good as I expected from Grizzly but ok for the price. It worked. The set screw holes appeared to be closer to the stop edge in the holder. I've tried different brands of dies and they all lock with set screws before they reach the stabilizing ring in the holder, which can result in your die not locking parallel to the holder and not perpendicular to your work. Be extra careful when installing the set screws.