💻 Grommet Plastic Computer Organizers Insert Review

I bought a set of 2" washers and after drilling the recommended 2" holes in my table the grommets are very tight. I would recommend a 1-15/16" or even 1-7/8" hole for a tight fit. The grommets are basically useless to my business now, I bought them to keep your cables running smoothly and now I have cheap grommets that don't stay as level as they should. If the seller had mentioned the need for a smaller hole I would have been much happier with my purchase.

I put them on the table for easy cable management. I didn't use them for the tabletop; Instead, I set them aside because that worked best for my setup. The 2 inch hole is a little big for the side of the table and the grommet didn't stay in place when I inserted it into the hole. This was easily attached with some black tape wrapped around the outside of the grommet to make it a bit thicker. This makes many cables a little less messy.

Installed them in a table I made from an 8 inch table top I bought from Lowes mounted on two two drawer filing cabinets. I used the 1-1/2" hole saw from the Harbor Freight Kit. They're a little loose, but I applied a few dabs of silicone caulk to the base to keep them in place. The one just above my UPS and my computer only ran out eleven wires. And they all fit! A good way to clean the wires from the countertop. Thanks for the goods to the seller Yujia!