💎 HENGDA Upgraded Manufacturing Jewelers Portable: Enhancing Jewelry Making Efficiency Review

Looks very high quality works well. NOTE: It must be lubricated with oil before use for the swivel function to work. Apply a few drops of machine oil around the side lever and drain; then turn upside down and apply a few drops of oil around the bolt/nut from below and allow to drain; Apply a few drops of oil around the seam where the two pieces meet (where it pivots) and let it drip off. After that, the hinge should work smoothly.

Inexpensive small vise, but there are some quality problems. You will need to cut and trim them to fit and/or fit small magnets into the pads. The pads on the vise attachment points are harder plastic and don't fit at all - you'll have to replace them with scraps of another material (silicone). , rubber, cork, leather, etc.). The iron case has some razor sharp edges during the casting process that you will need to file down. I was expecting cheap but it just is cheap - I could have taken the…

This small, inexpensive but sturdy vice came in handy when I needed to extend the legs of a filing cabinet. My first robot vacuum could vacuum under a closet with no problem, but its replacement was a bit taller and wider, and I really didn't feel like pulling out the closet or squirming around to get the job done. So I used a vise to hold the short pieces of an inch dowel in place while I drilled a hole in the center of each for a dowel screw to connect the extensions to the existing legs. It…