📏 HHIP 4400 0001 Indicator 001: Accurate Graduation Reading for Precision Measurements Review

Simple and inexpensive, the insides are clean and free of burrs, smooth action. For a cheaper indicator that a brand is on the windowsill, you can't go wrong. If you drop it, it won't hurt that much. I used this for use with the HFS(TM) magnetic backing. Magnetic indicator base Rear holder for AGD2 1 inch dial indicator so I wanted a cheap one as I would most likely damage these.

Very good value for money. I took it apart to fit a special measuring tool inside. There are cheap parts, this is not Mitutoyo. It has some play in the gears, but the tiny spring always tensions them for 0 net error. What I measure can have an error of 0.0001 inch, which is still very repeatable. Upper and bobbin threads are 4-48 , for fitting custom tips DO NOT hold the body and unscrew the tips, just hold the rod for it. It's the same size as the others with a 1ft reach, which is good for…

So far I'm very happy with this gauge, especially for the price. I've only used this for a short time but the accuracy and precision seems reliable, the readings have been consistent and the action is smooth.I bought a device with 0.0001" division and 0-0.25" range (HHIP 4400-1250). Off From the tests I can run I'm confident that the unit is giving good readings to within thousandths of an inch and seems stable to within a few ten thousandths of an inch (but that's on the edge of what I can…