Header banner
Revain logoHome Page
high-quality 100w wirewound resistors for power supply equipment - twidec aluminum housed resistor logo

High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor Review

2

·

Excellent

·

$$
Revainrating 5 out of 5  
Rating 
5.0
🧰 Passive Electronic Components, 💡 Industrial Electrical

View on AmazonView on ЯM

Media

(4)
img 1 attached to High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor
img 2 attached to High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor
img 3 attached to High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor
img 4 attached to High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor

Photos by authors

(1)
img 5 attached to High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor

Description of High-Quality 100W Wirewound Resistors For Power Supply Equipment - Twidec Aluminum Housed Resistor

Product Name: Aluminum Housed Wire Wound Resistor; Resistance Value: 1 Ohm;Power Rating: 100W; Resistance Tolerance: ± 5% (J). Body Size:59 x15 x15mm/2.3"x0.6"x0.6"(L*W*H);Soldering Mounting aperture:1.6mm;Fixed aperture:3mm;Terminal:2 Pin. Wound Resistor Aluminum housing for heat dissipation, suitable for cooling plate installation,High insulating capacity, can be used in atrocious environment. Wound Resistor Widely used in power supply, transducer, elevator, arena audio and high requirement equipment industry. Weight: 50g; Package Content: 2 x Aluminum Housed Wire Wound Resistors

Reviews

Global ratings 2
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Fixed my hyper flash

Replaced all the turn signal halogen bulbs with LEDs on my 2020 Miata. The front kit and rear kit both come with their own load resistors, but since I'm replace both front and rear I need to install two per side to fix the hyper flash. Measured the two resistors and did some calculation to find out what new resistor I need, also tested them in parallel to make sure it works. And I have to say, 4 ohm load resistors that is has the same mounting holes as the ones I already have are quite hard to…

Pros
  • Quick ship, good quality, accurate.
Cons
  • Didn't work

Revainrating 5 out of 5

Good quality - my new review

I used one between a power supply and seven little 12V fans to cut the noise and airflow. Works great. The leads smoke something awful when you solder them. They must have a coating of something on them.

Pros
  • Dummy load for amplifier test.
Cons
  • Not good for I bought it the 6 ohm was working perfect in my day light running