💡 Terminals Position Toggle MTS 103 by HiLetgo Review

After soldering the wire to one of the terminals, the toggle switch stopped working and froze in the off position. I tried another switch and it almost doesn't work. Before soldering the second, I thoroughly checked its work, but after soldering it with a low-power iron, it was extremely difficult to throw it aside. Failure to solder such lesions completely defeats the purpose as they are too small for screw terminals or push-in crimp terminals.

These switches have three positions (on-off-on) in a very small mechanism. Switching isn't smooth at all, and the padding for moving position is very inconsistent and rough. The angle for changing position is fairly small - probably only about 10 degrees - so it's not clear on visual inspection what position they're in. I haven't tested them to determine how much rebound they produce, but it's probably quite high. They're fine for use in a prototype, but I definitely wouldn't trust them in a…

I recently found a 3 way pickup coil wiring diagram online that shows the coils just the north coil in the top position, the humbucker in the middle and just the "South coil" disconnects" at the very bottom. That's the mini switch you need. They are well made and have a sense of quality. They work great and I upgrade all my guitars with them. Note. If you... don't want to use a mini switch for this application, use a push pull volume potentiometer instead.I prefer them for the ease of wiring…