🚗 Honda Genuine Parts 08P00-TLA-100 Splash Guard Set, 1 Pack - Enhanced SEO-Friendly Product Name Review

Instructions should be available. All of the supplied bolts are required, but only two of the supplied nuts are required for the underside of the rear fenders. Use one of the longer steel nuts and pan head screws on each side of the lower rear fenders. The rest of the Speed Nuts are for the 2015-16 Honda CR-V. The adjusting nuts included in the kit do not allow the inner tabs of the fenders to be correctly aligned with the vehicle skin. I recommend buying a set of 4 #10 flat nuts for the top of

Listed as fitting 2017 Honda CR-V. The fenders themselves fit the 2017 model, however the bottom of the rear fender is a bit narrow to fit the hole, you can attach it with a small screw - if you have two of those. Also the width of the clips for the inside of the wheel arches is too wide for the rear inner openings. You should leave about 1/3 of the clip outside of the clip's attachment point. Brackets don't snap. I wouldn't use them until 2017 unless you have the craftsmanship to make the…

I bought it to reduce the tail 🐓 that shoots out of the back of the car when it rains. I hate it because it makes my rear camera useless with all the wet spots. While driving through snow and mud I did NOT have to wipe the rear camera to see through. Tomorrow I'll ride in a snowstorm/rain and let you know if anything changes. Installation was easy. The front fenders come with only one screw as you are using 2 screws that are already on the car. I removed my 2 front tires because tightening the

They fit as expected but there were no instructions in my kit. See photo. The idea that a short screwdriver can do this without removing the tires isn't entirely true, especially for the rear wheels. I bought a Craftsman Mini 15 degree ratchet screwdriver that fits. The offset helps tighten the internal bolt from the front, and the leverage you get is useful for multiple bolts. Instructions found online. Finally, three spring clips/nuts are used on each rear fender, two large and one small. An…

I didn't find the installation as easy as many others but I don't have much experience with something like this. But the good news is, you don't have to do this beforehand to get it right. I wanted to save money and the prices to buy and install from dealers are exorbitant. I have a 2019 CRV EX. I used manuals from a Honda dealership which is easy to find online, a well known place to sell genuine Honda parts at a discount. I already had a push pin and Phillips screwdriver, but not a short one,