🚗 HOTSYSTEM New 3pc Car Truck Rocker Toggle LED Switch - Blue Light On-off Control: Amplify Your Vehicle's Control Panel with Style Review

Although the switch itself serves the purpose, the indicator should not be used! The indicator light gets VERY hot and will burn your finger if you try to turn it off. I use this rocker switch in combination with a Bosch relay to power an 18 watt (1.5 amp) LED bulb, so very little current flows through the switch itself. I have never had this problem with a rocker switch so use caution when purchasing this product. The check engine light gets hot enough to cause serious damage to your vehicle…

3 star product, average quality but at such a great price, half a star added. 3.5 stars are rounded up to 4. They come with no schematic, but the two silver spades are for the power input/output, and the copper pin needs to be connected to ground if you want a little light to come out. when the switch is on. What I probably like best about them is how close they are flush mounted, they don't stick more than 1/8 inch or so to their mounting surface. I don't see anything sticking to them or…

These are nifty little switches. I used them to connect backup lights and night lights in my pickup truck. They won't fit a 3/4 hole and I used an 11/16" bit and it worked fine. I made my own switch mount and was happy to see that the switch didn't rotate when installed. The light is pretty bright and easy to see even in daylight I wish they would offer other color indicators so I can color code my switches in the dark The switch is properly labeled and easy to hook up Auxiliary posts It's easy

They do what they advertise. A few notes for some people. 1) I definitely have LEDs. Confirmed by my meter, they don't pass the conductor at all until the minimum voltage is reached. 2) An LED with no current limiting resistor conducts almost like a short circuit until it dies a smoking death. 3) These switches are best not fully "on" and fully "off" with minimal effort/effort. So you have to make sure you're actually tapping (your finger) on it when you turn it on to make sure the pins inside…

If grounded so that the "LED" illuminates the switch, it gets very hot! I read several other reviews that commented on the same issue. These switches are rated for 16 amps, they shouldn't get hot when loaded with 3 amps! I used a switch for 2 x 18w off road high beam led headlights with a total draw of 3 amps so the electrical load is not a problem. I disconnected the ground from the LED in the switch and the heat problem went away. It got so hot I was afraid the plastic switch would melt. To…

I bought these to replace switches that look exactly like them. The difference is that these switches look and feel cheaper and weaker than the ones I removed. The ones I removed worked the opposite of these replacements, meaning that when the switch was in place the original had the indicator on top. When the top of the switch is pressed, the headlight and LED light up. If I set these switches to the same position as the original ones, with the LED indicator on top, you now have to press the…

I was very happy to find a set of three key switches at this price point and with Prime shipping as I was in a hurry to complete the van rebuild for the road ahead. to travel. These rocker switches look nice and well made, but they aren't. They are not LED so the reviews read that the light gets warm. By hot I mean hot. Leaving the light on and pressing the skin of the joint against it can burn you. I connected one of these buttons to a nice LED puck. I don't leave the light on for too long as…