🔧 Plumb eeze Pressure Tank Installation Kit: 1" Brass Union Tank Tee for Tanks up to 16" Diameter Review

Well I'm 72 and new to renovating my own fountain this set of quality components in one purchase has been a blessing! The T-bar design is unique in that where the T is located, there is an integral connector that allows the installer to make adjustments after the entire system is assembled: hydraulic tank, gauge and pressure switch can be pre-installed and fitted are then added to another part of the stem already attached to the hydraulic tank. final praise. The 12 year old PVC fittings on my…

Freezes well so the PVC pressure tank breaks on holiday. In preparation for the repair I discovered that the brass nipple to the pressure switch had rusted to the point of breaking in the tee. I decided to replace everything and use a tee with a fitting for access in the future. Everything was supplied as described and with the replacement of PEX with PVC the installation was as easy as you would expect. I switched from a 30/50 switch to a 40/60 switch, pressurized the tank to 38psi, turned on…

I may have been ruined by a roll of THICK yellow teflon that cost over $3 at Lowes because the white material that was included was very thin and every fitting I've used it on , was leaking. Teflon began to drip water at places of overlap. I've been running this type of tape for decades so it wasn't a setup issue. Anyway, the attached pressure gauge reads 10psi in atmosphere, so that's it. But since it's on the ground and I have several more accurate gauges at eye level, I won't swear by it…