💡 Waterproof 12V Van Interior Lights with 40 LEDs, White LED Lamp, LED Project Lens for LWB Vans, Boats, Caravans, Trailers, Ceiling Light Review

This is my second set of four so I have to say I like them. They are easy to separate if you need less light in different places. Or stretch them with lots of wire. They are hot - not specific and will burn out when 18 volts are applied. 14.5 was ok for her, but 18 kablowie. But if you have 12V, take it! Stick them to whatever you want with the sticky backing. It works great too. Highly recommended!

I bought these to replace some of the aquarium lights in my 55 gallon freshwater tank. The headlights, which were mounted on the hood, corroded and quickly failed. I bought these because they advertise water resistance and compatibility with an existing power supply. The glue is a 3M product and seems to be good. A few sealed solder joints and I saw the fish again. These lights were installed during the week and only in the evenings. A light bulb in a block of 4 has already burned out.

i like these lights in my work van. They are really bright. They put the factory installed LED lights to shame. Everyone at my place of work wants some as soon as they look in my van. I installed them on a piece of 3/4" PVC pipe with zip ties, then tied the pipe and connected it to the existing overhead fittings. This allows me to easily rotate them back and forth and if I change vans in a few years, can I take it with me.I also bought some for the trunk of my car and they light up really well…

Very easy installation thanks to crimp connectors. They can also be soldered with shrink wrap. I considered passing them from the trailer centerline but changed my mind to keep the setup very clean. I could have spaced them out, but instead I just placed them along the top edge. Super bright, provides plenty of light for loading and unloading. I would seriously consider replacing the regular interior lights with these. The photos were taken at dusk but I promise you they give enough light to be

(edited) These headlights are very bright. I have to mount them so that there is no direct view of the LEDs as they are very concentrated and bright. Pros: very bright and small. (The glue is strong, but you can also use small screws to fix it.) --> The glue is NOT strong. The headlights will detach themselves from the adhesive. (the real plastic part of the light with the sticky adhesive side) Cons: The wires connecting each light element are only about 3 inches long. As bright as they are,

I used this lighting in my switch bed assembly. The switch is behind the TV on a carpet strip. I cut off some velcro and attached them to the back of each light section to glue to the carpet lined cap. The lights are connected to my DC fuse box with a 3 amp fuse. I used velcro to hide and secure the wires you can see in the photo. Note. I had a short circuit problem in the first message I received. I contacted the seller and he fixed it with my money back so I was able to get another one which…

I didn't buy them for a car or RV. I bought these for some wooden poles I made using cheap solar lantern housings. I loved the metal and glass solar lanterns, but the small solar panels are plastic and quickly fog up, resulting in the lights not working for months. I used one of the four LED panels in each street light. The light is dimmable and works great with a 12 volt AC transformer in landscape mode. I have two 200 watt landscape transformers, one on each side of my house, for backyard…