Header banner
Revain logoHome Page
πŸ”’ lockdown gunsaver dehumidifier: slim, easy-install for vault humidity control & rust prevention logo

πŸ”’ LOCKDOWN GunSaver Dehumidifier: Slim, Easy-Install for Vault Humidity Control & Rust Prevention Review

6

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.7
🌦️ Dehumidifiers, 🌬️ Heating, Cooling & Air Quality

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”’ LOCKDOWN GunSaver Dehumidifier: Slim, Easy-Install for Vault Humidity Control & Rust Prevention
img 2 attached to πŸ”’ LOCKDOWN GunSaver Dehumidifier: Slim, Easy-Install for Vault Humidity Control & Rust Prevention
img 3 attached to πŸ”’ LOCKDOWN GunSaver Dehumidifier: Slim, Easy-Install for Vault Humidity Control & Rust Prevention
img 4 attached to πŸ”’ LOCKDOWN GunSaver Dehumidifier: Slim, Easy-Install for Vault Humidity Control & Rust Prevention

Description of πŸ”’ LOCKDOWN GunSaver Dehumidifier: Slim, Easy-Install for Vault Humidity Control & Rust Prevention

SPECS: 12 inches long with a 110-120 volt AC plug, 6 foot cord and protects up to 200 cubic feet. EASE OF USE: Rod features attachable legs for placement and a cord with a quick plug attachment to allow for the cord to be ran through the back of the safe and then plugged in. SECURE: Protects your firearms all while fitting in the smaller, less usable areas of the safe. RELIABLE: Removes moisture from the air in the gun safe to prevent rust build up. VERSATILE: Comes in 12" and 18" versions.

Reviews

Global ratings 6
  • 5
    3
  • 4
    1
  • 3
    0
  • 2
    1
  • 1
    1

Type of review

Revainrating 5 out of 5

Do what is advertised!

Works fine. The mounting clips need to be screwed in, not quite sure how to do that in the safe! So I just put it on the floor. It seems to produce enough heat to keep moisture at bay.

Pros
  • Holding my fists
Cons
  • Nothing

Revainrating 5 out of 5

This product works great

I liked this product for its easy installation. This dryer worked right away. You can tell whether a dehumidifier is working by the heat emitted by the stick. It's not hot enough to burn, but it's warm to the touch. If I needed another dehumidifier I would buy it from this company.

Pros
  • Free for educational purposes
Cons
  • Some cons

Revainrating 5 out of 5

Works as advertised. Relatively easy to install.

Works great. My safe didn't have a pre-drilled hole so making one wasn't easy. But when I did it, it worked great. Gets a lot hotter than I thought, but that's how it works. If I could do it again I might have thought about going down a size as I think that would be enough, but I've decided to go bigger or go home.

Pros
  • Not cheap but decent
Cons
  • Mostly good but...

Revainrating 2 out of 5

Spend a few bucks more and get the best.

Just got around to installing it. If I could send it back I definitely would. The electrical plug needs to be installed manually, but this makes it easier to route the cables. That's great. Although the bar mounts are cheap and don't snap. It's just on top. Would happily spend a few bucks more at $0.25 if there were better mounts.

Pros
  • Nice appearance
Cons
  • Low maintainability

Revainrating 1 out of 5

Product change - Revain shows one version but supplies another

Product shown [.] Product shipped was [.] (Above links to manufacturer's page were removed by Revain editors and replaced with [.]) Both products are Goldenrod branded but the product pictured is a Goldenrod desiccant and the second is a Gun Saver desiccant (also made by Goldenrod). Revain presents a higher quality end product and delivers a lower one. Added correct link to "Original" Golden Rod (article fahttp://www.amazon.com/Goldenrod-725741-GoldenRod-Original-Dehumidifier/dp…

Pros
  • Pleasant
Cons
  • Questionable purchase for the elderly

Revainrating 4 out of 5

If the plastic can withstand the temperature of the stick, then everything is fine. I read so many negative comments.

To rate 5 the product must exceed all expectations. Attaching the connector to the cable seemed a little iffy, but when it arrived I just CAREFULLY plugged the cable into the connector and spliced the two pieces together. After 5 minutes the rod felt warm. I used magnetic rod holders instead of gluing or screwing them to the inside of the closet. If the plastic can withstand the temperature of the stick, then everything is fine. I've read as many negative comments as possible but I've had this…

Pros
  • Great for a small home
Cons
  • Update Availability