Marketty Printer Compression Actually Perfectly Review

We were excited to install this product mentioned as an update from a youtube video as we were having trouble fitting the bed with the stock ender 3 per align springs . .They arrived quickly but the stiffer springs were too long causing our printhead to bang against the bed. Even fully compressing the springs with our weight on the bed and the dials fully screwed in wasn't enough. I strongly do not recommend these springs for Ender 3 Pro.

I was skeptical but they seem to require a lot less adjustment than the stock springs that came with my Creality Ender 3v2. I only needed 4 so I'm not sure what the value of 10 is. I would happily pay less for six fewer feathers. Maybe some customers buy them for multiple printers. In any case, if at some point in the rest of my life I need six very strong little orange screws, I'll be ready. I will update this review if that day ever comes.

These are springs, they work. But I had some problems. One of them had a piece of paint or maybe metal that had dried between layers of feathers so when I pressed it it just didn't flatten out on one side, after researching I had to use a needle nose to pry something out from between the feathers . It was definitely there when it arrived because it was glued on with the yellow paint used to finish the feathers. Then, after installing 4 springs, one corner of my bed doesn't sink as low as the…