🔍 Mirro 92508 Pressure Cooker Gasket 8-Quart for Model 92180 and 92180A - White Replacement Seal Review

I have an old Mirro pressure cooker that the gasket is gone so I ordered this so called replacement - THIS IS NOT! it fits (diameter) but it's thinner than the normal original so it doesn't make a proper seal to the vacuum - I'm so disappointed - my pressure cooker is fine except for this seal - I've tried replacing it with another new one to replace (pressure cooker), but the quality of the new ones is not as good as the originals - even bad in my opinion. I'm so upset that I've used my…

I wish I had a new one for a long time; This new one fits much better and therefore seals much faster. That's great! You know I had 3 bad experiences since I wrote this amazing review; This new gasket is thinner than the original gasket from the 1970's and flipped three times as the cap "screwed tight" and the pressure pushed it out of the cap rather than through the top opening which is scary. and can be dangerous. I know the seal is installed correctly, the cover is installed correctly, and…

I've used my last pad for over five years; It worked ONCE and then failed the second time. I heard a terrible noise in the kitchen and fell in as liquid started pouring from the stove. I put everything under the tap and everything was fine. I figured I'd clean it well and try again next time; it was even worse. Within seconds all the soup was on the stove and on the floor. Nobody got hurt but it was pretty scary. I emailed the seller asking for a replacement and was told it's been too long…

I bought an old (albeit new) Wear-Ever (Mirro) pressure cooker at a garage sale for $10 and was happy to use it. Initially, I was able to get it to pressurize after a few minutes of steam escaping. I've never had a pressure cooker and found it ok. Then I couldn't increase the pressure at all. I contacted Mirro and after giving them the model number. I was advised which pad to take. The product arrived quickly and I was delighted. At first I thought the spacer was too big as it *almost* crumpled