🚗 MOERTIFEI Car Mudguard Fender Mud Flaps Splash Guards Compatible with VW Tiguan 2018-2021 (Excludes Tiguan R-Line) – Top-Quality Protection for Your Vehicle Review

I bought this brand for the Atlas and Tiguan. Easy to assemble, looks good and feels solid. I'm not sure about the composition of the material, but at first they stink. The smell will dissipate after a few uses, but I wouldn't recommend inhaling it.

Nobody should give them less than 5 stars. OEM quality and features. The dealer asked $110 + tax for a set of 4. Very easy to install, just wish they would provide torque bolts like the original bolts already used in the wheel well. Not a big deal, but you'll need a right-angle screwdriver or a 1/4-inch socket with a flat-head Phillips screwdriver. This only applies if you don't want to remove the rear wheels, as the front wheels can be rotated in the opposite direction that you are working on…

The first thing you notice upon opening the package is that it smells of typical Chinese plastic and low quality rubber that smells like heavy oil. Combination of contact cement, roof tar and road tar during installation. The plastic is very hard unlike most factory units which are much more malleable and flexible. It's thin too. They will most likely break if you accidentally step off the curb or anything that comes in contact with it. Another problem is that this can damage the hull as it is…

These fenders fit my 2019 Tiguan S perfectly. I used the screws that came with it as they had a thicker thread. The rear fenders were installed using the two existing wheel arch bolt holes and I removed the T15 plastic screw from the underside and replaced it with the included Phillips head screw. I found it easier to start with the middle screw, top screw, and bottom screw. For the front fenders I started with the bottom screw as it needed more alignment to attach, the middle screw and then…

Fenders fit my 2019 Tiguan SEL almost perfectly. I left the factory bolts for the inside of the wheel well and used the supplied bolts for the single bottom hole as the factory bolts weren't long enough to deal with the extra fender thickness. I had to make my own hole at the top for the front ones, but that was through the plastic trim so it wasn't too difficult. I used an angled mandrel and a rubber mallet to make the pilot hole because my drill didn't fit in the wheel area. There were T20…

I bought these for my 2020 Tiguan. I was impressed with the quality. The front set is easy to assemble. I can't install the rear kit yet. As other reviewers have pointed out, it appears to require three bolts - two in the wheel well and one under the bumper. Two wheel well bolts are quick and easy, although you'll have to use a right-angle screwdriver since the tire gets in the way. However, the tab under this bumper aligns with the attachment point where my plastic rear bumper appears to be…