🚦 Enhanced 6-12V Blue Blinker Relay for Motorcycle Turn Signals Review

Fits perfectly on my 1983 Kawasaki KZ1100 Spectre. Works excellently with both turn signal circuits and hazard warning flasher circuits. It beeps to remind me to turn off the turn signal if the auto shutoff doesn't turn them off.

Zero stars if I could. This Hotazz brand turn signal relay did not work and contrary to my usual experience with Revain I have to return it for more money than it was worth. Buy from another seller if you have to take a risk on this particular flasher.

I've read reviews that say it doesn't matter which cable goes where, but with the one I have it really matters. The terminals aren't marked so I connected one way and it didn't do anything, but when I swapped the wires I got both a beep and flashing turn signals. and I just didn't see it. All in all it works for me.

Simple but does the job. Was a perfect replacement for my old motorcycle flasher relay. It was installed in the same place and allowed me to get rid of a separate buzzer which I connected to the flashing circuit. I didn't notice much delay before the signals started. As mentioned in other reviews, the volume of the buzzer can be adjusted by taping the hole in the speaker with tape. But for me it works the way it is because I hear a buzzer over the engine noise which is what I needed.

Update: The seller contacted me and received an apology and a refund for the flasher. Applause for the seller's performance and excellent customer service. I bought this to partially restore my 1980 Suzuki ST100. That does not work. It squeaks very loudly, but the turn signals don't come on. You really do get what you pay for. If you need turn signals to work on your old 6 volt bike, this won't work. Spend money on OEM parts.

The annoying beeping could be tolerated if it carries enough current to adequately illuminate the lamps. With the engine on or off and a fully charged 6V battery, the lights barely came on, and even then it was fast enough that it could pose a safety hazard on the road. Turned it on thinking maybe the beeper was sucking too much voltage out of the flasher relay, but when I cut the beeper wire it all stopped working. I should have spent a few euros more for something else. This thing was…

I read in a review that it is too loud. They advised sealing the speaker with electrical tape. A big mistake for me. It's loud at idle, of course, but you can't hear it when riding with the wind, engine and helmet on. Ninja 300 with standard muffler. No noisy bike. I changed my rating from 5 to 3 stars after road testing and found I couldn't hear it at around 20mph due to helmet, wind and engine noise. I had to "listen" for the sound otherwise I might not notice it even at low speed. It would…