🚤 Enhance Your Boat or RV Safety with NEW SUN Trailer Boat RV Red LED Lights: Surface Mount, 10 Diodes, Bullseye Clearance Side Marker Light 2-Pack Review

It's a chore when installing on an existing platform that is difficult to retrofit. I'm replacing Peterson's single wire headlights with these. The screw holes line up and are about the same size, but the wiring is off-center, and replacing a single wire involves jumping through multiple hoops, distributing the lights, and soldering the ring terminal to ground. Wires and drill the body to let the plus through, then glue the headlights back on. Luckily there's a good wire holder for the ground…

looks good but one of my lights is missing a bulb so only two lights work. Unfortunately it was the last one I installed. When it didn't light up and I removed the lid I was upset that I didn't see any light there at all, so obviously that's how it was sent from the factory. They were easy to install, but you need a ground, so keep that in mind if you're used to a single wire that grounds itself. Not sure how they will hold up, they weren't nearly as strong as the bulbs I replaced. The time…

Two things. There are no photos of the back of the flashlight body. Many RVs have a hole in the middle for the bus wiring to run through. These lights don't have that, however, and are designed so that you can squeeze the wiring between the car's outer wall and the body of the light. The wires are too thick for the space provided and the lamp body is not adjacent to the car. Requires additional silicone sealant. They are intended for something like a trailer where you can run wires through a…