🧹 NIUPIKA Soft Nylon Brush Set for Cleaning and Polishing with 2.35mm Shank, 30-Piece Pack for Rotary Drill Tools Review

Super for fine, detailed cleaning, but the brushes don't last long. If necessary, use them only for small jobs. Anything else you have to use something else.

I bought these to test and gently buff stones, but they not only damage stones, they just abrade at low speeds. Don't get them unless you have a soft surface to buff and even then I don't think they will last long.

That's my only complaint about getting it out of the way. The shaft is smaller than usual on my old Dremel. My fault for not checking it out. So check. Also, they work in my drill and do their job well. They give you the life you expect for money. Although they held the drill well

They look good for what they are so I give them a full five stars. They were as described and the quality of the bristles is comparable to the quality of the brushes that came with my Dremel when I bought it. But I didn't check the shaft diameter before buying. I have a flexible connector that fits these wider shank brushes, but I would like to advise other buyers to make sure you are ordering the correct size before ordering. I know so little about the Dremel ecosystem that I just didn't…

I haven't had any positive experiences with them at all. Even before you use the brushes, i.e. just turn them in the Dremel, they are slightly deformed by the turning movement. And the deformation is irreversible, that is, you cannot return the bristles to their previous state. In addition, the bristles break or splinter. And it was just from the twist, not touching anything. As I used the brushes to clean the smooth ceramic surface, the number of chips and breakages increased significantly…

Being at home due to the current pandemic, I have decided to use my 3D printer to make face shield parts. road, adjusting printer settings to reduce the need for parts cleaning, and my first few batches were rough and required a lot of post-processing. A while back I discovered that these small nylon brushes with a rotary tool are very useful for post-processing 3D printed parts. . I have ordered several official Dremel brand brushes and have been using them ever since. When I wore out a brush…