🚰 Oatey 43789 White 3-Inch x 2-Inch: Reliable and Versatile Plumbing Solution Review

Its diameter was too large for the 3" PVC pipe I encountered. I had to wrap two rolls of JB water welds around it to keep it from dripping.

Attaches to a 3 inch basement pan floor. Fits snugly on a 3" pipe and a 2" pipe snugly fits on the fitting. Good quality product.

Does exactly what it's supposed to, Easy installation and no leaks if done right! I recommend placing it where you need it and drawing a circle on the inside and then cutting it out with a hole saw. After that, sand the tube and seat tee and wipe clean, then apply a generous amount of cement to both sides and hold the pressure until it sets, after which you can install the included brackets for extra security. The cement itself should be enough to hold it together

I bought these saddle tees to solve a ventilation problem between my upstairs and downstairs toilets after I had a bathroom in my upstairs bathroom (unit upstairs). ground floor) had a new high-efficiency flush installed that now bubbles when the top block is flushed away). Due to the many connections for the bathroom, kitchen and sink, it was impossible to install a standard tee without dismantling the entire system. These tees allowed me to install the ventilation with minimal tearing and…

Didn't work for me. Used Oatey brand primer and cement and they leaked. I made about a dozen connections and the only thing that didn't work was the seat tee. Another thing I don't like is that the instructions require you not to touch the connection for two hours before applying the clamps. I had to crash into a sewer line that could not be moved from either end of the tee. Buy a hygiene t-shirt and rubber boots. You don't have to go through the trouble I went through. Oatey should make one of

I needed to hook up a 2" pipe to a vent pipe, what seemed like an easy project but turned into a puzzle. I bought rubber tees and all kinds of connectors. I saw that you can't put in a tee with limited access to the vent pipe, you would have to redo the entire vent pipe all the way to the roof! a product that allowed me to drill a hole and connect my new pipe. And after a long search I finally found this product! What a lifesaver! I drilled a hole and kept it clamped with a pair of quick clamps