Orbit Industries FLB R1G BR Adjustable Receptacle Review

It took some work to fix this but my setup was to remove the old poorly made outlet and replace it with this one. Reinstalling should be easier. Looks great with my new floor

I installed this in my kitchen to connect power to the island. I took the advice from the previous review and placed the flange piece underneath and bolted it to the sub floor. Worked great.

The quality is good. We replaced some of the old sockets on the floor with these. However, they did not sit flush with the floor. Still about 1/2 inch stuck. I just covered them with a rug but the only reason I bought them was to make sure the sockets were flush with the floor.

Well designed bottom hopper. Installing the first one takes a little time, but it's easy once you get the hang of it. The height adjustment is very easy, so you can adjust the floor covering exactly. Designed for installation in a subfloor with a finished floor laid on top. At this point the height can be adjusted.

This product performs best when installed over a subfloor before carpet, tile or wood paneling is installed. When installed on a finished floor it will sit about a quarter of an inch. The idea is that you can adjust the final height to work with any height of your finished floor. To easily remove the screw-on exhaust plugs, insert a quarter into the slot, then grasp the quarter with pliers and unscrew the plug. Overall, the installation was pretty easy.

Floor funnel in normal design. Installing the first one takes a little time, but it's easy once you get the hang of it. Adjusting the height is a breeze, so you can tailor it to your floor. Designed for installation in a subfloor with a finished floor laid on top. At this point the height can be adjusted.

This product works best when installed on a subfloor before a carpet, tile or hardwood floor is laid. When installed on a finished floor it will sit about a quarter of an inch. The idea is that you can adjust the final height to work with any height of your finished floor. To easily remove the screw-on exhaust plugs, insert a quarter into the slot, then grasp the quarter with pliers and unscrew the plug. Overall, the installation was pretty easy.

I find this funnel to be very well designed and of good quality. Easy to install and easy to adjust to fit exactly at floor level. It fits perfectly on my finished floor. Cut a simple 2.5" x 4" hole and attach an adjustment bracket to the underside of the sub-tray (ignore the countersinks). You will need an S2 (#8-9-10) square head screwdriver for the adjustment screws. One more note: I connected the outlet to the load side of a separate GFCI outlet, good practice for a floor outlet.