🔌 Enhance Relays & Switches with PACK AMP Waterproof Relay Harness Replacement Parts Review

This product was PERFECT as a replacement for the trim and tilt relay on my boat. Original equipment from Volvo was a 30/40 amp relay that had constant problems, also the place where the relay was installed got very wet. These relays seem to work MUCH better than the factory relays so far with no issues.

Used to control nitrous oxide solenoids that draw 4-6 amps. This relay race accepted him as champion. The 12v is used to drive the relay and solenoid which require battery power. High precision screw rails and spade connectors are used to make all connections very strong.

I used these to replace the sealed jack control module on my boat. This was a much more economical solution and gave me spare relays to boot. The relay worked great from the start. The gasket on the outlet appears to be of good quality. Everything corresponds to the description and works perfectly.

If anyone is looking for these to replace the relay on the CMC socket board they fit snugly and work like a charm. Also, I only used two, so I have three spare relays. I didn't need the female connectors with pigtail wires as mine were still in good condition but will be kept for the future. I bought them solely for the relay.

I've seen a lot of relays! 30 to 40 amps with smaller contact sizes than 30/40 amps usually have larger contact sizes for pins 30, 87 and 87a. Sorry I'm very skeptical of them and I won't be using them for my 60 amp circuit. I'm sorry if I'm wrong about this product, but I trust my instincts. I will use them for a lower current circuit.

I'm not sure how they think the 12g harness will handle 80 amps so I don't know if the relay will actually handle that much current. Regardless, I hooked it up to a circuit that draws 27 amps at full load, which supposedly tripped 30 amp relays. I guess if it suits my needs I really don't care if it's overrated or not. I've tested it for 3 hours of continuous full load use and so far so good. It warms up a bit, but not enough to bother me. Luckily, it won't be under full load that often, and…

Used for Polaris Ranger UTV reverse light. The other type you can buy as a pre-wired solution is a non-waterproof relay. This relay is waterproof. Durable and clearly marked for the pen. Great instructions are right here on their page, as well as instructions for grounding or a positive trigger. Pair this device with a pair of waterproof clips and know you don't have to worry. I could have gone for the 30 amp version, but for a few bucks I can use it for other things and not worry about wasting